Section 3
Sensor Setting/Monitoring/Operating Functions from Configurator
Setting the Communication Unit and Sensors, and
Downloading
Generally, setting communication units and each sensor is done by the following
procedures.
1. Select and double-click the applicable communication unit. The following [Edit
Device Parameters] dialog box will appear.
2. Edit each parameter.
• Settings of each sensor (fiber amplifier unit)
1)[Click the [▼] button on the right of [Sensor #xx] (xx is unit No.) in the [Sensor
Configuration] field, then select a fiber amplifier unit type from the pull-down list.
2)Click the [Set...] button on the right of the registered fiber amplifier unit type.
The following [Edit Sensor Parameters] dialog box will appear.
E3X-DRT21-S
78
User's Manual