Table of Contents
Advertisement
SECTION 9: Configuration
9-1 Setting the sensor using the push buttons
The sensor is set by means of three push buttons. With these push buttons, the user navigates through the
setting menus, through which all necessary sensor settings can be made.
If no keys are pressed for 2 minutes during set-up, the sensor returns automatically to run mode.
9-1-1 Display in the normal mode
Depending on the user set-up, the sensor's display shows the following in the run mode:
•
Status LED is turned off.
•
Digital display:
The current received light intensity is depicted in the bar chart.
The flashing display " ---- " appears in the event of a short-circuit at the outputs. The sensor continues
normal functioning once the short-circuit at the outputs has been remedied.
9-1-2 Main menu structure
The following figure shows the structure of the main set-up menu.
Normal
operation
Enter 2 s
When the Enter
key is pressed for 2 seconds, the sensor switches from the normal mode to the SET menu
path. The sensor switches to each next menu path when the Enter
onds. If no key is pressed for more than 2 minutes, the sensor returns to the normal operation state.
In the menu paths, the required parameters can be selected by pressing the
•
For Enter a parameter or a selection: Press the Enter
•
For switching to the next main menu point: Press the Enter
•
To skip a menu path, you can also press the Enter
9-1 Setting the sensor using the push buttons
5et
Enter 2 s
+ / -
Menu path
SET
Function
settings
key < 1 second.
key > 2 second.
key for 4 seconds.
0pt
Enter 2 s
+ / -
Menu path
OPTIONS
Additional
settings
key is repeatedly pressed for 2 sec-
and
keys.
31
Advertisement
Table of Contents
