Operating Environment And System Configuration - Omron SYSMAC CP1E-E20DR-A Datasheet

Connecting to Support Software

Operating Environment and System Configuration

The following system is required to operate the CX-Programmer. Make sure your system provides the following conditions and has the necessary
components.
Item
Supported computer IBM PC/AT or equivalent
CD-ROM or DVD-ROM drive One or more
Windows 7, Windows Vista, Windows XP,
Supported Operating Systems Windows 2000 (Service Pack 4 or later)
(except 64-bit edition)
CPU Pentium II 333 MHz or faster
RAM 256 MB min. 512 MB or more recommended
Available hard disk space 600 MB min.
Display 800 x 600 SVGA min.
PLC and connection port USB port
Connecting Methods
Using commercially available USB cable, connect the CX-Programmer to the peripheral USB port on the CPU Unit.
CX-Programmer
A connector
Commercially available
USB cable *
B connector
Peripheral USB port
(Conforming to USB 2.0, B connector)
Note: The CX-Programmer cannot be used if it is connected to the built-in RS-232C port or serial option port of a CP1E CPU Unit.
* Commercially available USB cable: 5 m max., for USB 2.0.
Connecting Cable
Use the following cable to connect the CP1E CPU Unit to the computer running the Support Software.
Port at Unit
Peripheral USB port
(Conforming to USB 2.0, B connector)
CP1E-E@@D@-@ CP1E-N@@D@-@/NA20D@-@
Description
USB port
CP1E CPU Unit
Port at computer
USB port
Network type
(communications mode)
Commercially available USB cable
USB 2.0 (or 1.1)
(A connector - B connector)
Model numbers Length
Less than 5 m
33