Startup Mode Setting - Omron CJ - PROGRAMMING MANUAL 08-2008 Programming Manual

Startup Settings and Maintenance
6-6-2

Startup Mode Setting

Auxiliary Area Flags and Words
Name
IOM Hold Bit A50012
PLC Setup
When using the CX-Programmer, make the settings on the Startup Tab Page.
The following table shows the corresponding settings when using a Program-
ming Console.
Program- Name
ming
Console
address
+80, bit 15 IOM Hold Bit
Status at Startup
The CPU Unit's initial operating mode (when the power is turned on) can be
set in the PLC Setup.
PLC Setup
When using the CX-Programmer, make the settings on the Startup Tab Page.
Address
When this bit is ON, all of I/O memory will be
retained when the operating mode is
changed (PROGRAM ↔ RUN/MONITOR).
Setting
0: The IOM Hold Bit is cleared to 0 when
power is turned on.
1: The IOM Hold Bit is retained when
power is turned on.
Operating mode
Power ON
Section 6-6
Description
Default
0
(Cleared)
323