Selection At Program Start - Sennheiser S-MCD 3000 HP - V1.2 Instructions For Use Manual

1 Setting receiver addresses automatically
You can distribute all addresses automatically via the "Set All Addresses" button.
• The allocated receiver addresses are then displayed in the "System Addresses" field. The order of
the addresses depends on the order in which the receivers are connected to the PC.
• The current receiver address can be shown in the receiver display via the "Show Addresses" button.
The receiver display is set back to the default frequency display via the "Reset" button.
• All receiver addresses present in the "System Addresses" field can be displayed via the "Read"
button.
2 Manual setting of the receiver addresses
The current receiver addresses can be shown in the receiver display via the "Show Addresses" button.
• You can set the desired address using the Up/Down keyson the receivers. All receiver displays are
reset to the default frequency or channel display via the "Reset" button.
• All receiver addresses present in the "System Addresses" field can be displayed via the "Read"
button.

6 Selection at program start

Once you have determined the ports, you come to another selection window. This window allows you
to choose between several start options:
54