Using The Receiver - Sennheiser EK 1038 Instructions For Use Manual

Using the receiver

12
Using the receiver
Switching the receiver on/off
To switch the receiver on, turn the volume control
until it clicks. The red LED
displayed.
Note:
The receiver has a short switch-on delay.
Remove the batteries or the rechargeable battery when the
receiver will not be used for extended periods of time.
To switch the receiver off, turn the volume control
clockwise until it clicks. The red LED
go off.
Note:
If you insert the active receiver into the L 2015 charger to
recharge it, the receiver automatically gets off. It even remains
inactivated when you take it out of the charger. Then you will
have to primary switch it off and then on again as described
above.
Adjusting the volume
You can adjust the volume at the headphone output on the trans-
mitter.
Danger of hearing damage!
CAUTION!
Listening at high volume levels for long periods can
lead to permanent hearing defects.
Set the volume for the connected headphones to
the minimum before putting the headphones on.
Adjust the volume of the connected headphones via the volume
control button so that you can clearly and precisely under-
stand the speaker.
Switching the channel
If several guided tours take place within a building and several
transmission links are operated at the same time, the user can
switch the channel of the receiver to the channel that is stated by
the guide.
lights up and the current number is
and the standard display
clockwise
counter-