Care And Maintenance - Sennheiser EK 1038 Instructions For Use Manual

SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophones
Muting the radiomicrophone
The radiomicrophone has a
audio signal without switching the radiomicrophone off.
Turn the protective cap
so that the MUTE switch
Set the MUTE switch to the position 'MUTE'. The "MUTE" display
appears on the radiomicrophone's display panel.
Set the MUTE switch back to the original position to retrans-
mit the audio signal.
Operation and battery status indication
The red LED (LOW BAT/ON)
operating state of the radiomicrophone:
Red LED lit up: The radiomicrophone is switched on and the capacity
of the batteries/BA 2015 rechargeable battery is sufficient.
Red LED flashing:The batteries are/the BA 2015 rechargeable bat-
tery is going flat (LOW BAT)!

Care and maintenance

Use a slightly damp cloth to clean the radiomicrophone from time to
time.
Note:
Do not use any cleansing agents or solvents.
To clean the radiomicrophone's sound inlet basket, proceed as fol-
lows:
Unscrew the sound inlet basket (turn counterclockwise) and
remove it.
Remove the foam insert.
Use a slightly damp cloth to clean the sound inlet basket from
the inside and ouside.
Reinsert the foam insert.
Replace the sound inlet basket on the radiomicrophone and
screw it tight.
MUTE switch that noiselessly mutes the
at the bottom of the radiomicrophone
becomes accessible.
provides information on the current
31