Table of Contents
Advertisement
Putting the diversity receiver into
operation
Inserting the batteries/accupack
For powering the diversity receiver, you can either use two 1.5 V AA size
batteries or the rechargeable Sennheiser BA 2015 accupack or the DC 2
power adapter (see "Accessories" on page 23).
Open the battery compartment by pushing the two catches
direction of the arrows and open the cover
Insert the two batteries or the accupack as shown above. Please
observe correct polarity when inserting the batteries/accupack.
Close the battery compartment by pressing on the center of the
cover
.
The battery compartment cover
click.
Charging the accupack
To charge the BA 2015 accupack:
Insert the diversity receiver into the L 2015 charger (see "Accessories"
on page 23).
The L 2015 charger can only charge the combination BA 2015
accupack/diversity receiver. Standard batteries (primary cells) or
individual rechargeable battery cells cannot be charged.
Mounting the diversity receiver to a camera
Use the supplied CA 2 camera adapter to mount the receiver to a camera's
flash mount.
Determine where on the perforated plate
adapter
will need to be fastened so that the receiver can best be
attached to the camera.
At this position, place a square nut
Fasten the flash mount adapter
square nut
Putting the diversity receiver into operation
.
.
locks into place with an audible
under the perforated plate
to the perforated plate
in the
the flash mount
.
using the
7
Advertisement
Table of Contents
