Table of Contents
Advertisement
Using the diversity receiver
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see next section).
2. Switch a transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the receiver's RF level display
"RF"
reacts.
It is vital to observe the notes on frequency selection on page 19.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter "Synchronizing a transmitter with the diversity
receiver" on page 19.
Switching the diversity receiver on/off
Push the two battery compartment catches
compartment cover
To switch the diversity receiver on:
Press the
ON/OFF
The red
ON
LED
Name" appears on the display panel.
To switch the diversity receiver off:
Keep the
ON/OFF
panel.
The red
ON
LED
When in the operating menu, pressing the
cancel your entry (ESC function) and return you to the current
standard display.
.
button
.
lights up and the standard display
button
pressed until "OFF" appears on the display
goes off and the diversity receiver switches off.
Using the diversity receiver
and open the battery
»
ON/OFF
"Frequency/
button
will
9
Advertisement
Table of Contents
