THOMSON SPEEDTOUCH 546 - VERSION 6 Installation And Setup Manual page 18

Chapter 2
Basic Installation
12
3
Make the following connection:
Connect the yellow RJ-45 Ethernet cable to the yellow Ethernet port on
your SpeedTouch™ and the other end to the computer's Ethernet port.
4
Once the hardware is installed and connected to the SpeedTouch™, the
procedure continues with configuring your Internet connection.
If the wizard does not detect a connection, an error message will be
displayed. Refer to
page 31.
Proceed with " Configuring the Internet connection" on page
" The wizard does not detect a connection" on
13.
E-DOC-CTC-20051017-0068 v1.0