Air Intake/Exhaust Air; Steam Connection (Only For Steam-Heated Variants); Hot Water Connection (Only For Hot Water-Heated Variants); Gas Connection (Only For Gas-Heated Variants) - Miele PDR 914 Operating And Installation Instructions

Air intake/exhaust air

The tumble dryer may only be operated when the ducting has been
connected properly and the room is sufficiently ventilated.

Steam connection (only for steam-heated variants)

The steam connection must only be carried out by a registered install-
ation technician. The enclosed installation instructions must be ob-
served as they are important for the steam connection.

Hot water connection (only for hot water-heated variants)

The hot water connection may only be carried out by a registered in-
stallation technician.
The installation instructions must be observed as they are important
for the hot water connection.
If a stopcock is desired, it must be fitted on site.

Gas connection (only for gas-heated variants)

The gas connection may only be carried out by a registered installa-
tion technician in accordance with the applicable national regula-
tions.
The use of a gas socket for the supply hose is not permitted as
the flow rate is too low for the specified heater rating.
The gas heating is configured at the factory in line with the gas spe-
cifications on the sticker on the rear of the appliance.
If the gas type needs to be changed, please request the appropriate
conversion kit from the Miele Customer Service Department. Inform-
ation is required on the appliance type, serial number, gas family, gas
group, gas connection pressure and country of installation. This gas
conversion may only be carried out by a registered specialist.
 Risk of electric shock and injury due to using the tumble dryer
without the complete casing.
If the casing is dismantled, it is possible to come into contact with
live or rotating machine parts.
Once the tumble dryer has been installed, replace all the casing
parts that were removed.
Installation
51