Mounting - Smeg SI 3642B Manual

L (mm)
900
After laying the adhesive sponge (A) on the glass
surface (see 8.5 Hob seal) and after positioning and
securing the hob, fill the edges with insulating
silicone (B) and wipe away any excess. In the event
the glass surface has to be removed, cut the
silicone using a cutter before attempting to remove
it (C).
Enough silicone must be used to create a seal between the hob and the counter top, but not so much as
to fasten the appliance to the counter top. To fasten the appliance see "8.6 Fixing using brackets".

8.3 Mounting

8.3.1 Over empty kitchen unit or drawers
If there are other pieces of furniture (lateral walls,
drawers, etc.) under the hob, a double-layer
wooden base must be installed at least 30 mm from
the bottom of the hob to avoid any accidental
contact. It must only be possible to remove the
double-layer base using suitable equipment.
opens on bottom
46
Instructions for the installer
X (mm) Y (mm)
882 332
G (mm) H (mm)
904 354
opens on rear
A (mm) B (mm)
50 min. 50 min.
C (mm)
750 min.