Smeg SC170-8 Manual page 51

Instructions for the installer
12.4 Positioning the oven
Never use the oven door to lever the oven into place when fitting. Avoid exerting
too much pressure on the oven door when open.
It is recommended to install the oven with the help of a second person.
The base on which the oven is resting must be complete as shown in the
illustrations below.
The oven is designed for
mounting into any piece of
furniture as long as it is heat-
resistant. The adjacent figure
shows the indicative overall
dimensions of the appliance.
For installing under a work top,
follow the dimensions given in
paragraph "12.4.1 Positioning
under a work top".
When installing in tall units,
comply with the dimensions
shown in paragraph "12.4.2
Installing in tall units", bearing in
mind that the top/rear of the unit
must have an opening
approximately 35-40 mm deep.
When installing under a work top, allow for a rear and bottom clearance of
approximately 60 mm (as shown in the figures below).
See the relevant instructions for fitting and securing a hob.
105