Seat Latch And Adjustment; Pre-Operation And Daily Safety Checklist - Husqvarna HUV4420-D Owner's Manual

SEAT LATCH AND ADJUSTMENT

The seats are hinged to allow easy access to the engine compartment. A latch at the rear of each seat bottom
keeps the seat from moving on its hinges while the vehicle is in operation. To disengage the latch, grasp the
seat back and pull firmly in a forward/upward direction until the latch releases. To engage the seat latch, push
down firmly on the seat back until the seat locks into place. See following WARNING.
ý
WARNING
• Make sure seat hinges and latch are securely engaged before operating vehicle.
The driver-side bucket seat is adjustable and can be moved forward or backward to accommodate the driver.
To adjust seat, push lever located under the driver seat to the left (towards outside of the vehicle). Position
seat and return lever to its original position. See following WARNING.
ý
WARNING
• Do not adjust driver-side seat while vehicle is in motion.
To adjust the passenger-side seat:
1. Remove the seat from the vehicle.
2. Remove the four bolts and washers from the bottom of the seat mounting plate.
3. Align the mounting plate holes with holes in the seat to achieve the desired seat position.
4. Install washers and bolts and tighten to 96 in-lb (10.8 N·m).
5. Install seat in the vehicle. See preceding WARNING "Make sure seat hinges and latch...".

PRE-OPERATION AND DAILY SAFETY CHECKLIST

Each Husqvarna vehicle has been thoroughly inspected and adjusted at the factory; however, upon receiving
your new vehicle(s), you should become familiar with its controls, indicators, and operation. Carefully inspect
each vehicle to ensure that it is in proper working condition before accepting delivery.
Use the following checklist as a guide to inspect the vehicle. This checklist should be used daily to ensure that
the vehicle is in proper working condition and in conjunction with the Periodic Service Schedule on page 29.
Any problems should be corrected by a Husqvarna dealer/distributor or a trained technician.
• General: All the parts should be in place and properly installed. Be sure that all nuts, bolts, and screws
are tight. Check hose clamps for tight fit.
• Safety and information decals: Check to ensure that all safety and information decals are in place.
See pages 4 through 7.
• Roll-over Protective Structure (ROPS): Check to ensure the ROPS is not damaged and all hardware
is secure. See Roll-over Protective Structure (ROPS) and Safety Belts on page 17.
• Safety belts: Visually inspect for cuts, fraying, and loose parts. See Roll-over Protective Structure
(ROPS) and Safety Belts on page 17.
• Tires: Check for proper tire pressure. Visually inspect tires for wear, damage, and proper inflation on a
daily basis. See Vehicle Specifications on page 47.
• Battery: Check electrolyte to ensure it is at the proper level (Figure 36, Page 44). Check battery posts.
Wires should be tight and free of corrosion and battery should be fully charged.
2005 HUV4420 and HUV4420-D Gasoline and Diesel Vehicle Owner's Manual
Seat Latch and Adjustment
Page 19