Seat Latch And Adjustment - Husqvarna HUV 5420 DX Owner's Manual

Seat Latch and Adjustment

WARNING
• In the event of a roll-over, do not attempt to jump or otherwise exit the vehicle. Remain seated with
seat belt fastened and with arms and legs inside the vehicle.
• After inserting the tab, make sure the tab and buckle are locked and that the belt is not twisted.
• Loose fitting seat belts could increase the chance of injury due to sliding under the belt if sudden
braking should occur. Keep the seat belt snug and positioned as low on the hip bone as possible.
• Use a single seat belt for one person at a time. Do not use a single seat belt for two or more people –
this includes children.
• No more than one person per bucket seat at one time. No more than two persons per bench seat at
one time. Do not allow people to ride in any part of the vehicle that is not equipped with a seat and a
seat belt. Do not allow a passenger to hold a child in his or her lap while the vehicle is moving.
• The Husqvarna vehicle is not designed to meet child seat compatibility requirements. Children
requiring a child safety seat must not ride on the vehicle. Comply with state and local laws pertaining
to child safety.
CAUTION
• Be careful not to damage the seat belt webbing or hardware.
• Inspect the seat belt system periodically. Check for cuts, fraying, and loose parts. Damaged parts
should be replaced immediately. Do not disassemble or modify the system.
• Keep seat belts clean and dry. If cleaning is necessary, use a mild soap and lukewarm water solution.
Do not use bleach, dye or abrasive cleaners as they may severely weaken the seat belts.
• Do not insert coins, clip, etc. in the buckle as this may prevent the tab from locking into the buckle
properly.
• If the seat belt does not function normally, contact your dealer/distributor or trained technician
immediately. Do not occupy the seat until the seat belt is repaired.
SEAT LATCH AND ADJUSTMENT
The vehicle seat(s) are hinged to allow easy access to the engine compartment. To raise the seat bottom, grasp the
rear side of the seat bottom, and pull firmly in a forward/upward direction. See following WARNING.
WARNING
• Make sure seat hinges and latches are securely engaged before operating the vehicle.
Vehicles with bucket seat option:
The driver-side bucket seat is adjustable and can be moved forward or backward to accommodate the driver. To adjust
this seat, push the lever located under the driver seat to the left (towards outside of the vehicle). Position the seat, and
return the lever to its original position. See following WARNING.
WARNING
• Do not adjust the driver-side seat while the vehicle is in motion.
To adjust the passenger-side seat
1. Remove the seat from the vehicle.
2. Remove the four bolts and washers from the bottom of the seat mounting plate.
3. Align the mounting plate holes with holes in the seat to achieve the desired seat position.
Page 18 HUV 5420 DX All-Wheel Drive CE Mark Diesel Vehicle Owner's Manual