Front Shock Absorbers - Husqvarna HUV4420-D Owner's Manual

Gasoline and diesel vehicles

Hide thumbs Also See for HUV4420-D:

Owner's manual (61 pages)

Service manual (75 pages)

Table Of Contents

Table of Contents

WARNING

• When servicing the vehicle with part of the vehicle on jack stands, do not operate the engine

with the Forward/Reverse handle in either the FORWARD or REVERSE position. The all-wheel

drive system will engage any wheel(s), front or rear, with traction. See Figure 2 on page 11.

Under most circumstances the driver will not need to do anything to engage the AWD system; however, the

front differential may become locked (rotate at the same speed regardless of the terrain) under certain condi-

tions. If the front differential becomes locked, drive slowly in reverse for at least 10 feet (3 meters), then brake

gently. See following WARNING.

WARNING

• Reduced steering control can occur if the front differential becomes locked. To help prevent

this condition, avoid extremely hard braking in reverse.

STOPPING THE VEHICLE

To stop the vehicle, release the accelerator pedal and press the brake pedal until the vehicle comes to a com-

plete stop. See following WARNING and CAUTION.

WARNING

• Driving through water may affect the brakes. After driving through water, check effectiveness

of the brakes by gently pressing the brake pedal. If the vehicle does not slow down at the

normal rate, continue to press the brake pedal until the brakes dry out and normal

performance returns.

CAUT ION

• When stopped on a hill, use the brake pedal to hold your position. Do not use the accelerator

pedal to hold position.

PARKING AND LEAVING THE VEHICLE

1. After stopping the vehicle, firmly set park brake. Make sure it is fully engaged. This will prevent the vehi-

cle from rolling.

2. Turn the key switch to the OFF position, remove the key, and place the Forward/Reverse handle in the

NEUTRAL position.

Gasoline vehicles only: Turn the fuel shut-off valve to the closed (OFF) position when the vehicle is not

in use (Figure 10, Page 26). See also Figure 32 and Figure 33 on page 42.