Operating Conditions - Culligan Iron-Cleer Plus Owner's Manual

Automatic water filter
Hide thumbs Also See for Iron-Cleer Plus:
Table of Contents

Advertisement

Operating
Conditions
4
The concentration limits listed below reflect the maximum individual limit that each contaminant was
tested for separately without any interference of other contaminants in the influent water.
In reality, however, we know that these contaminants may be present in combination which may limit
the filter's ability to remove these contaminants in higher concentrations. In some cases, individual
sellers of this equipment have had success removing higher concentrations of contaminants - iron, for
example - above the limitations we have listed. If you are considering the installation of this system
for the reduction/removal of iron, manganese and/or hydrogen sulfide beyond the printed operating
conditions below, we recommend that you consult the manufacturer for proper application. Installation
of this system under these circumstances may void part(s) and/or all of the system warranty.
pH — The pH level of the influent water must be 6.5 - 8.5. A pH level of 7.0 - 8.5 is optimal for iron
reduction and a pH level of 6.5 - 7.5 is optimal for hydrogen sulfide reduction.
Iron — This system is rated for a maximum of 10 ppm of ferrous (clear water) and/or ferric (red
water) iron. Consult the factory if iron bacteria is present.
Hydrogen Sulfide — Often referred to as rotten egg odor, hydrogen sulfide will be reduced
significantly on water supplies containing less than 5 ppm. Consult the manufacturer if hydrogen
sulfide concentrations is greater than 5 ppm.
Organic Matter (Tannins) — The presence of organic matter such as tannins will prevent the
oxidation process of converting the dissolved element, such as iron or manganese, to a non-soluble
precipitate or solid substance, allowing it to be filtered out. The Iron-Cleer
organic bound iron.
Filtered Non-Softened Water
Softened &
Filtered Water
Water
Softener
Note: Waste connections or drain outlets shall be designed and constructed to provide for
connection to the sanitary waste system through an air gap of 2 pipe diameters or 25.4 mm
(1 in.) whichever is larger.
Unfiltered Water To Outside Hosebibs
Iron-Cleer
Iron-Cleer
Iron-Cleer
Filter Tank
Aeration
Tank
Figure 1
is not designed to remove
®
Raw Water In

Advertisement

Table of Contents
loading

Table of Contents