Installing The Appliance - Smeg F608SN Manual

Instructions for the installer

11.INSTALLING THE APPLIANCE

11.1 Electrical connection
The identification plate bearing the technical data, serial number and brand
name is visibly positioned on the appliance.
Do not remove this plate for any reason.
The appliance must be connected to earth in compliance with electrical system
safety regulations.
If a fixed connection is being used, fit the power line with an omnipolar circuit-
breaker in accordance with the installation rules, located in a position which is
easy to reach and near the appliance.
If a plug and socket connection is being used, make sure that the plug and
socket are compatible. Avoid use of adapters and shunts as these could cause
overheating and a risk of burns.
Operation at 220-240 V~: use a H05V2V2-F type
2
three-core cable (3 x 1.5 mm ).
The end to be connected to the appliance must
have an earth wire (yellow-green) at least 20 mm
longer than the others.
WARNING: The values indicated above refer to the cross-section of the internal
conductor.
58