Installing The Appliance - Smeg Oven Instructions For The User

2. INSTALLING THE APPLIANCE

This appliance has fire protection (type Y) and can be installed against
walls higher than the work surface.
In compliance with Electromagnetic Compatibility regulations, the
electromagnetic induction hob is classified in Group 2 and Class B (EN
55011)
2.1 Electrical connection
Make sure the voltage and the cross-section of the power supply line
match the specifications indicated on the identification plate positioned in
the storage compartment.
Do not remove this plate for any reason.
Fit the power supply line with a multipolar cut-out device with a contact
opening gap equal to or greater than 3 mm in an easily accessible
position close to the appliance.
The appliance has a terminal board on its rear for the electrical
connection (see diagram below). To access it, remove the back cover.
6
Instructions for the Installer