Connecting Spoolmatic; Or 30A Or Spoolmate 200 Gun - Miller Millermatic 355 Owner's Manual

5-20. Connecting Spoolmatic

7
wrench
5/8 in
crescent wrench
1 Gun Trigger Plug
2 Weld Cable
3 Shielding Gas Hose
Route gun trigger plug, weld cable and gas
hose through opening in panel.
nutdriver
Insert plug into receptacle, and tighten
chippinghammer
threaded collar.
4 Drive Casting
15A Or 30A Or Spoolmate 200 Gun
®
3
3
6
4
5 .375–16 Nut (167788)
Remove the nut from the drive casting.
Use nut to connect spoolgun weld cable
to drive casting.
6 Gas Hose Routing Hole
To route gas hose through rear panel, drill 1
in. hole through bottom of rear plastic bezel.
Align drill with pilot dimple in plastic bezel
visible from inside wire drive compartment.
2
5
2
291542-A
7 Gas Hose Fitting
Route shielding gas hose through wire drive
compartment, out opening in rear panel, and
up to regulator/flowmeter. Connect gas hose
fitting to regulator/flowmeter.
OM-288360 Page 33
1
5