Step
Screw (quantity)
2
M1.6 × L2.4 mm, flat-head, nylon-coated (4)
Step 2.
Install the Pogo pin cable in reverse order.
Volume board and cable
Follow the instructions to replace the volume board and cable.
For access, remove these FRUs in order:
• "LCD module" on page 56
• "Built-in battery" on page 60
Step 1.
Remove the volume board and cable as shown below.
a.
Disconnect the connector. Loosen the screws and then remove the volume board and cable.
Color
Torque
Silver
0.098 Nm
(1.05 kgf-cm)
.
Chapter 8
Removing or replacing a FRU
67