Table of Contents
Advertisement
Installation
CAUTION!
No service or maintenance should be performed until the technician
has thoroughly read this service manual. Except for routine cleaning
and sanitizing, only qualified technicians should attempt to service
or maintain this equipment.
Countertop Installation
The Champion 7 countertop model is designed to fit on counters underneath
standard mounted cabinets, this does not apply to Champion 15 models.
1. 3" (7.62 cm) on each side of dispenser, 2" (5.08 cm) behind for
electrical/water connection/ventilation (Fig. 1).
2. Rough-in the electrical service and water line.
§ Water: supply line (with shut-off valve) connects to the dispenser's
1/4" OD tube quick connect.
NOTICE!
If installing optional Drip Tray Drain Kit or Leg Accessory,
complete those steps before proceeding.
CAUTION!
Use caution when tipping the dispenser during leg installation. Do
not lay unit on back or side. DO NOT EXCEED 30° angle. Tipping
more than 30° can result in compressor malfunction.
3. If installing optional 4" Leg Accessory (item# 00956300), place a
5" (12.7 cm) spacer underneath the dispenser to ease installation.
4. Remove four plastic, thread-protecting plugs from bottom of
dispenser.
5. Screw each leg into chassis (Fig. 2).
6. Complete Potable Water Connection before proceeding.
Fig. 1
countertop models
minimum 3" (7.6 cm)
clearance required
Fig. 2
Dispenser and Ice Machine - 230 V
9
Advertisement
Table of Contents
