Table of Contents
Advertisement
MV7+ Yoke Assembly
The MV7+ yoke allows a podcaster to be flexible with mic placement. Loosen the yoke knobs and you can adjust the micro
phone in a variety angles. If the microphone becomes detached from the yoke, these are the steps to put it together in the cor
rect order to ensure that your microphone is secure. Each side uses one thin gray spring washer, one shiny silver brass wash
er, two black plastic washers and the yoke and threaded yoke knob.
1.
Start with the threaded knob flat side down on your tabletop.
2.
Stack the washers on the threaded knob.
◦
Place a black plastic washer on the knob.
◦
Place one side of the yoke on next.
◦
Then put the second black plastic washer on.
◦
Place the flat silver washer and then the thin spring washer on the threaded knob.
3.
Using your finger to hold the screw assembly in place, slide the MV7+ onto the threaded screw and turn the
knob to keep washers in place.
Note: Be sure to keep this side on but loose so that you have room to easily move the yoke and assemble the washers
on the opposite side.
4.
On the opposite yoke arm, place the washers into the side of the MV7+ in reverse order. Thin spring washer >
Flat silver washer > Black plastic washer > Yoke arm
Overall Dimensions
Shure Incorporated
14/17
Advertisement
Table of Contents
