Raise the level on both the MV51 product and the host computer for proper monitoring. 3. Confirm that the MV51 is the selected audio device. Plug headphones into the MV51 device audio output and play an audio track. If you can hear sound, the microphone is functioning properly.
Touch Panel Interface Controls Touch Panel ① Volume Control Slider ③ Mute Button Adjust microphone or headphone level by Press to mute and unmute the microphone. sliding your finger across the control surface. ④ Mode Selector Press the mode button to activate Press to select preset mode.
Page 5
To record a band with drums or amplified Additional Tips instruments, aim the microphone towards the Shure offers additional educational publications on group at a distance of 6 to 15 feet (1.8 to 4.6 m). recording techniques for specific instruments and Placement of the microphone depends on the size applications.
Listening Through Headphones Accessing the Control Panel The MV51 is equipped with a headphone jack to allow you to monitor audio from the computer and 1. Open the sound control panel and select the microphone. The signal is an equal blend of the Recording tab.
Troubleshooting Issue Solution The display does not illuminate Make sure that the MV51 is fully plugged in. Audio is too low Check the computer sound control panel settings. When first connecting the MV51 to your computer, make sure to raise the computer volume level.
Authorized European representative: turning the equipment off and on, the user is encouraged Shure Europe GmbH to try to correct the interference by one or more of the Headquarters Europe, Middle East & Africa...