Table of Contents
Advertisement
Use of batteries
Operation notes
Concerning the Remote Control
Battery installation
Open the
1 Open the cover.
Press the lever and move the cover in the direction of the
arrow.
2
Insert the batteries.
Use four manganese batteries (RO3 (UM-4) "AAA" 1.5 Vj].
Do not mix old and new batteries, or batteries of different types
(carbon and manganese, etc.).
Always
remove
old, weak or worn-out batteries promptly and
dispose of them properly.
The battery life is about 6 months.
Although the battery life varies depending on how often the device
is used, the batteries should be replaced about once every 6
months on the average.
Because a fairly large power is required in order to enter other
remote-control signals into the memory of this unit, note that the
batteries will weaken faster if such memory entries are made
often.
The batteries should be replaced if commands from the remote
control transmitter do not operate the unit even when the transmit-
ter is held close to the front panel or when the display becomes
dim during operation.
Aim
the
remote
control's
transmission
window toward
the unit's sensor. Avoid any
obstacies.
When operating components
other
than
compact
disc
player and cassette tape deck
face the remote-control trans-
mitter
toward
the
remote-
control
signal
receptor
of
each component.
Use the remote control within
a 60 degree angle and within
6 meters (20 ft.) from the unit.
6 meters
(20 ft.)
The audio control panel of the remote control may be covered by a
clear plastic protective sheet. This sheet may be removed
if
desired.
—42—
insert the
batteries.
Close the
cover.
Be sure that the batteries are inserted so that their positive
(+) and negative (—) polarities match the polarities indicated
in the compartment.
Batteries installed Incorrectly may leak
and cause damage.
Refer to "Use of batteries" for additional information.
3 Close the cover.
Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
Since this unit retains the memory of the "learning" keys for about
one hour from the time the batteries are removed, when replace-
ment is necessary, be sure to have the new batteries ready at hand
before removing the old batteries.
lf the memorized codes are erased by not replacing the batteries
quickly, reprogram this unit again. The original pre-programmed
remote-control codes are not erased.
If a battery leaks, remove
all batteries and dispose of them
properly.
Thoroughly
clean
the battery
compartment
before
inserting new batteries.
If the electrolyte comes into contact with skin or clothes, flush with
water immediately.
Keep batteries out of reach of children.
Do not use rechargeable (nickel-cadmium) type batteries.
Avoid dust
Avoid dust
Be sure the transmission window and the unit's sensor are free
from dust. Excessive dust might prevent reception.
The operation may not be correct if direct sunlight or another
strong light source strikes the remote control signal sensor part of
this unit. {f there is a problem, place the unit away from the light
source.
This remote control transmitter Is pre-programmed with the
remote control codes to enable operation of Panasonic AV
units. However,
if the range of the existing remote control
transmitter
is extremely
short,
if your
AV
unit
is not
manutactured
by
Panasonic,
if It is manufactured
by
Panasonic but with different pre-programmed remote control
codes, program the remote control codes from the remote
control transmitter included with your AV unit into this remote
contro! transmitter before operation. (See page 68 tor details.)
Advertisement
Table of Contents
