Table of Contents
Advertisement
Tuner section
51] Power "o STANDBYION" switch
(POWER, () STANDBY/ON)
This switch switches ON and OFF the secondary circuit
power only. The unit is in the "standby" condition when this
switch is set to the 6 STANDBY position. Regardless of the
switch setting, the primary circuit is always "live" as long as
the power cord is connected to an electrical outlet.
52] Remote-control signal receptor
(REMOTE SENSOR)
Receives the signals from the remote-control.
53) "STANDBY" indicator (STANDBY)
This indicator illuminates when the power switch of this unit or
that of the remote-control is switched "OFF". Its purpose is to
alert the user of the constant supply voltage to the internal
circultry even with the power switch OFF.
Preset-tuning buttons (1—0)
(30 CHANNEL RANDOM PRESET TUNING)
These buttons are used to preset broadcast frequencies into
the memory of this unit and to recall the desired preset
stations. (Refer to pages 21—23.)
[55] Tuning contro! (TUNING)
This control Is used to select an FM or AM broadcast.
When turning the control to the left, the frequency changes
downward.
When
turning
the
control
to the
right, the
frequency changes upward.
Tuning-mode selector/indicator
(TUNING MODE)
Each time this selector 's pressed, the selection changes, in
sequence, to "AUTO", "MANUAL" and "LOCK".
—13—
AUTO:
In this
position,
broadcast
channels
are
automatically
selected when the tuning contro! is momentarily turned to the
left or right to start the frequency changing.
MANUAL:
In this position, the tuning control can be used to locate the
desired channel manually.
The frequency changes only as the tuning control is turned to
the right or left.
LOCK:
tn this position, the broadcast channel presently being heard Is
locked in, and other broadcast stations cannot be tuned to,
even if the tuning control is turned.
[57] Band selectors
FM: Press this button to listen to an FM broadcast.
AM: Press this button to listen to an AM broadcast.
This button is also used to select the frequency step for AM
broadcasts. After a AM
broadcast
is received, when this
button
is pressed continuously for about 3 seconds, the
AM frequency step will change to 10 kHz. (This unit is set
to 9 kHz before shipment.) In order to return to the original
frequency step, press this button for about 3 seconds again.
FM mode selector (FM MODE)
This unit automatically switches to the stereo mode when an
FM stereo broadcast is received. This selector Is used to
select the mode (stereo or monaural) of FM broadcast signals.
Memory scan button (MEMORY SCAN)
This button is used to locate a desired broadcast station; each
broadcast station is selected for about 3 seconds.
Memory button (MEMORY)
This
button
is used
when
presetting
broadcast
station
frequencies into memory. (Refer to page 21.)
Advertisement
Table of Contents
