Table of Contents
Advertisement
Memory presettings coninues
Automatic memory presetting
Have you completed the steps (on page 18) of
"Basic Operating Procedure" ?
When this method is used, the frequencies of the selected broad-
cast stations are automatically preset (in sequence from lower to
higher frequencies) into memory: "channels" 1 to 30 are available
for the presetting of FM stations, and "channels" 21 to 30 are
available for AM stations.
When a presetting is made to a channel that has already been
preset, the prior presetting will be erased, so If, for example, FM fre-
quencies are preset to channel 1 to 30 and then AM frequencies
are preset, the first AM frequency will be preset to channel 21 (thus
erasing the FM presetting to channel 21), the second AM frequen-
cy will be preset to 22 (erasing FM 22), and so on.
1
2
Press the "TUNER" button.
Press the "FM" or "AM" button.
Before presetting AM broadcast stations, press to select the
appropriate frequency step for your locality.
(Refer to item [87] on page 13.)
3
Select the desired tuning mode, "AUTO" or
"MANUAL".
Back-up memory
The back-up function maintains the preset memory and the most-
recent memory (see below) when the power is switched OFF, in the
event of a power failure, or if the power cord is disconnected.
The memory will be maintained for as long as approximately one
month.
Most-recent memory
The most-recent memory system "remembers" the broadcast sta-
tion last tuned to when the unit was switched OFF. That station will
be automatically tuned to when the power is switched ON.
TUNING
MODE
4 Tur the tuning control so as to set to the
frequency
from which
you want
to start
automatic memory presetting.
In "AUTO" mode, the next station, higher or lower in broad-
cast frequency, will be automatically tuned in.
In "MANUAL"
mode, the frequency will change, using the
smallest step available, only as the tuning control is being
turned. This will allow you to tune in all of the broadcast
frequencies available in that band.
Press the memory button until the frequency
begins to change.
(Automatic memory presetting will start.)
For automatic pressetting in areas where there are fewer than 30
stations for FM broadcasts, the remaining channels will be left
unused. The unused channels can be filled by following steps 2
through 6 (on page 21.)
If frequency presettings are accidentally erased
1. Switch ON the power switch for an hour or longer.
2. Repeat the frequency presettings procedure once again.
Advertisement
Table of Contents
