Intel® Server Raid Controller U3-1 Setup And Installation; Overview Of Setup And Installation For Local Administration Of Nt Server; Setup And Installation For Local Administration Of Microsoft Windows Nt* Server.2-21; Installing The Operating System On An Srcu31 Raid Volume, A Pass-Through Disk Or Other Storage Device Or Installing Srcu31 Into A System With An Existing Operating System - Intel U3-1 User Manual

2.5 Intel® Server RAID Controller U3-1 Setup and
Installation
Note:
The Intel Server RAID Controller U3-1 may not come with a memory module (DIMM). If the
memory socket (indicated in
DIMM into the memory socket as indicated in
approved memory list at: http://support.intel.com/support/motherboards/server/srcu31.
2.5.1 Overview of Setup and Installation for Local Administration
of NT Server
This chapter describes the installation procedures for SRCU31 on NT Server. These procedures
include hardware installation, the creation and configuration of a RAID volume, OS installation
and the installation of the SRCU31 software on servers requiring the ability to be locally managed.
Figure 2-19
Figure 2-19. Installing the Operating System on an SRCU31 RAID Volume, a Pass-through
Disk or other Storage Device or Installing SRCU31 into a System with an Existing
Operating System
Begin
Installation of
Gather Required
OS on a Software and
SRCU31 Hardware
Volume
Begin
Installation of
Gather Required
OS on a
Software and
Pass-Thru or
Hardware
other Storage
Device
Begin
Installation of
Gather Required
SRCU31
Hardware
into a System
and
with an
Software
Existing OS
2.5.2 Setup and Installation for Local Administration of Microsoft
Windows NT* Server
2.5.2.1 In this Section
•
RAID Requirements for Microsoft Windows NT Server 4.0
•
Installing Microsoft Windows NT Server 4.0 on a Intel® Integrated RAID Volume
•
Installing Microsoft Windows NT Server 4.0 on a Pass-through Disk or other Storage Device
Intel® Server RAID Controller U3-1 User's Manual Rev 1.0
Download from Www.Somanuals.com. All Manuals Search And Download.
Figure A-2) is not populated with a DIMM, install an approved
illustrates the typical uses for this product.
Create Bootable
Install
RAID Volume
Adapter Card
Using RCU
Create Pass-Thru
Install
Disk and Select it
Adapter Card
as Boot Volume
Using RCU
Back Up
Update the OS
Server
Advanced Installation Steps
Figure A-2 before proceeding. Refer to the
Create OS
Install OS on a RAID
Installation
Volume
Driver Diskette
Install OS on a
Create OS
Pass-Thru or
Installation
other Storage
Driver Diskette
Device
Run
Install
SRCU31
Adapter Card
Setup
Run
SRCU31
Setup
Run
SRCU31
Setup
2-21