Controls Identification - Scag Power Equipment V-Ride XL Series Operator's Manual

Section 4
ENGINE THROTTLE
CONTROL
ENGINE CHOKE
MOWER DECK
CONTROL SWITCH

4.2 CONTROLS IDENTIFICATION

1. Ignition Switch (Figure 4-2). For electric start
models, the ignition switch is used to start the engine
and has three positions; OFF, ON, and START.
2. Mower Deck Switch (Figure 4-2). Use to engage
and disengage the mower drive system. Pulling up
on the switch will engage the deck drive. Pushing
down on the switch will disengage the deck drive.
3. Engine Choke Control (Figure 4-2). Use to start a
cold engine.
4. Engine Throttle Control (Figure 4-2). Use to
control the engine speed. Pushing the lever forward
increases engine speed. Pulling the lever back
decreases engine speed. Full back position is the
IDLE position. Full forward is the cutting position.
5. Check Engine Light (Figure 4-2). Indicates the
operation of the engine sensors on the Fuel Injection
Engines (EFI). If a problem occurs with a sensor
on the engine, the light will flash a code.See your
Authorized Scag Power Equipment Dealer for
diagnosis and repair.
CHECK ENGINE
LIGHT
IGNITION SWITCH
TIGER EYE
PARKING BRAKE
CONTROL
HOURMETER
LEFT STEERING
CONTROL
Figure 4-2. Controls and Instruments
6. Left Steering Control (Figure 4-2). Use to control
the mower's left wheel when traveling forward or
reverse. See Section 4.5 for further details regarding
the mower's travel controls.
7. Right Steering Control (Figure 4-2). Use to control
the mower's right wheel when traveling forward or
reverse. See Section 4.5 for further details regarding
the mower's travel controls.
8. Parking Brake Control (Figure 4-2). Use to engage
and disengage the parking brakes and lock the
steering handles in neutral. Pull the lever back to
engage the parking brakes. Push the lever forward
to disengage the parking brakes.
9. Deck Lift Lever (Figure 4-2). Use to raise and lower
the cutter deck.
10. Cutting Height Adjustment (Figure 4-2). Use to set
the cutter deck at the desired cutting height.
11. Fuel Tank Gauge (Figure 4-2). Indicates the
amount of fuel in the fuel tank.
12. Fuse Holders (Figure 4-2). Two 20-amp fuses
protect the mower's electrical system. To replace
fuses, pull fuse out of the socket and install a new
fuse.
15
R
FUSE HOLDERS
CUTTING HEIGHT
ADJUSTMENT
DECK LIFT
FUEL GAUGE
FUEL SHUTOFF VALVE
RIGHT STEERING
CONTROL