Operator Cushion And Rear Cover Removal; Adjusting The Operator Suspension Platform - Scag Power Equipment V-Ride XL Series Operator's Manual

R
6.8 OPERATOR CUSHION AND REAR
COVER REMOVAL
The operator cushion and rear cover can be easily removed
to gain access to the machine for maintenance.
WARNING
Before removing any guards, shut the engine off
and remove the ignition key. Wait for all moving
parts to come to a complete stop before beginning
work.
To remove the operator cushion and rear cover:
1. Loosen the two (2) wing nuts securing the operator
cushion to the machine. See Figure 6-12.
2. Lift upward to remove the operator cushion. See
Figure 6-12.
3. Remove the two (2) wing nuts securing the rear
cover to the back of the machine and remove the
cover. See Figure 6-12.
WARNING
Do not operate the machine without the operator
cushion or rear cover installed.
1
3
Figure 6-12. Operator Cushion and Rear Cover
6.9 ADJUSTING THE OPERATOR
SUSPENSION PLATFORM
The operator suspension can be adjusted to optimize the
operator comfort and ride. Adjust the suspension rate by
moving the mouting position of the rubber isolators back to
increase (stiffen) or forward to decrease (soften) the ride.
MOVE BACK TO MAKE FIRM
RUBBER
ISOLATORS
Figure 6-13. Operator Suspension Platform
34
Section 6
2
1
3
Removal
Adjustment