Troubleshooting - ResMed Power Station II-V2 User Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
Storing
CAUTION
The battery pack must be charged to 100%, indicated by four green LEDs
and switched off before storing. You must recharge the battery pack to 100%
again after six months of storage. When not in use, all lithium-ion batteries
self-discharge over time. If not periodically recharged (ie, every six months),
the battery pack will eventually self-discharge to the point that it can no
longer be recharged. If this occurs, the battery pack is no longer usable and is
unrecoverable.
Store the battery pack in a cool, dry place.
Note: When left switched on, a fully charged battery pack self-discharges to 0% of
full capacity within four weeks of storage. When switched off, the battery pack self-
discharges to 0% of full capacity within six months of storage.
Servicing
The battery pack is intended to provide safe and reliable operation when used and
maintained in accordance with the instructions provided by ResMed. There is no
servicing necessary during the lifetime of the battery pack.
The intended design life of the system excluding the battery pack is 2 years. The
intended design life of the battery pack is 500 recharge cycles. After 500 recharge
cycles, the battery pack will last about 60% of the time from its original condition. A
full charge in an older battery pack will not last as long as in a new battery pack. As
with all electrical equipment, if any irregularity becomes apparent, you should exercise
caution and contact an authorized ResMed service representative.
Traveling
Consult with your carrier if you intend to take the battery pack on board with your
device.

Troubleshooting

If there is a problem, try the following suggestions. If the problem cannot be solved,
contact your equipment supplier or ResMed. Do not attempt to open the battery pack.
Problem / Possible cause
Device is not running
Power connections are disrupted.
The battery pack is discharged.
The battery pack is off.
Solution
Check all cables and connect them as described in
Setting up.
Connect the device to the mains power supply and
recharge the battery pack.
Set the DC on / off switch to on.
English 5

Advertisement

Table of Contents
loading

Table of Contents