Control Panel - ResMed Power Station II-V2 User Manual

Notes:
• Not all devices are available in all regions.
• Air10 DC cables are used only with AirSense 10 / AirCurve 10 / Lumis series and power supply units.
• To recharge the RPSII-V2 using power supply units supplied with the AirSense 10 / AirCurve 10 / Lumis series,
an RPSII-V2 Air10 PSU adaptor (part no. 24706) is required.
• For information on battery run times, refer to the Battery / Compatibility List on www.resmed.com/downloads/devices.

Control panel

Refer to illustration B.
The control panel of your battery pack includes the following:
1. Audible alert mute button
2. Charge level check button
3. DC on / off switch
4. DC input / output port
5. Audible alert mute indicator
Setting up
CAUTION
• Ensure the battery pack and the device are turned off before setting up.
• When the battery pack is plugged into the mains power supply, ensure all
cables are properly connected.
Charging the battery pack
Refer to illustration C.
1. Attach the power supply unit adaptor to the DC plug and connect it into the battery
pack DC input / output port.
2. Connect the AC or DC power cord to the power supply unit.
3. Plug the other end of the AC or DC power cord into the mains power outlet.
Notes:
• Charging takes less than 4 hours from 0% battery pack charge level to greater
than 95%.
• To discontinue charging, unplug the power cord from the mains power outlet.
Providing power to the device
Refer to illustration D.
1. Select the correct output voltage for your device using the voltage output selector
from the battery pack rear panel.
2. Connect the appropriate DC cable to the battery pack.
3. Connect the other end of the DC cable to the device.
4. Set the DC on / off switch to on.
Providing backup power to the device (for systems with both AC and DC inputs)
WARNING
In this configuration, the Stellar draws power from the battery pack first until it
is fully discharged and will not recharge. As a result, once all power has been
discharged from the battery pack, it will not act as an AC backup.
2
6. Battery charge level indicators
7 . Charging indicator
8. DC switch / discharging indicator
9. Voltage output selector switch
(rear panel)