Cleaning And Maintenance - ResMed Power Station II-V2 User Manual

LED indicator
Flashing green
Constant green
DC on / off (B-8)
Flashing blue
Constant blue
Audible alert mute (B-5)
Flashing blue
Constant blue
When setting the DC on / off switch, the charge level indicator may fluctuate between different levels.
1
To check the battery pack charge level, press the charge level check button (B-2) on the
control panel. The number of green LEDs indicates the approximate charge level.
To mute the alert, press the audible alert mute button (B-1). To permanently mute,
press and hold the audible alert mute button (B-1) for 5 seconds. To deactivate, press
the audible alert mute button (B-1) when the mute is still active.
Using humidifiers
When the Stellar device is integrated with the H4i humidifier and is not connected to
the mains power supply, the humidifier will only operate in passive unheated mode
despite the warm-up message appearing on the device. When the device is connected
to the mains power supply, it will return to active heated mode.
AirSense 10, AirCurve 10, and Lumis series operate normally in active heated mode
when connected to the battery pack or to the mains power supply.

Cleaning and maintenance

WARNING
Do not immerse the battery pack in water, and do not use liquids to clean any part
of the product.
1. Disconnect the battery pack from the power supply unit and the device. Remove
all cables.
2. Wipe the exterior of the battery pack, battery coupler kit, DC cables, and adaptors
with a clean cloth.
4
Status
Charging
Fully charged
Battery pack turned on but not discharging
Battery pack turned on and discharging
Not discharging and mute is active
Discharging and mute is active