Emergency Keep-Alive; Exiting Emergency Operation; Exiting Emergency As Supervisor (Trunking Only) - Motorola APX 8000HXE 3.5 User Manual

MN004482A01-AN
Chapter 7: Advanced Features
Scenario
If you change to a channel or mode with Emergen-
cy capability while in Emergency operation,
If the radio is out-of-range of the system or the
emergency alarm is not acknowledged,
7.10.2

Emergency Keep-Alive

This feature prevents your radio from turning off when in Emergency mode. If this feature is enabled, you are
required to exit Emergency mode before turning off your radio.
7.10.3

Exiting Emergency Operation

If an Emergency operation is triggered on your radio, the dispatch console or radios configured as Supervisor
can exit the Emergency operation.
Procedure:
To exit Emergency operation, press and hold the programmed Emergency button.
7.10.4

Exiting Emergency as Supervisor (Trunking Only)

Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch console
must be preprogrammed to use this feature. For more information, contact your system administrator.
Procedure:
Perform one of the following actions:
If...
If the emergency mode is initiated
by other radios,
If the emergency mode is initiated
by the Supervisor,
NOTE: The combinations of the following buttons are supported in your radio:
● Radio Side Button 1 and Top (Orange) button.
74
Outcome
● The display for Model 3.5 and Model 2.5 shows
No emergency.
● The display for Model 1.5 shows NO EMERG.
the Emergency Alarm and/or Emergency Call con-
tinues on the new channel or mode.
your radio shows the following indications:
● A tone sounds.
● The display shows No acknowledge.
Then...
press and hold the Side Button 1 and press the Emergency
button.
Perform one of the following actions:
● Press and hold the Emergency button.
● Press and hold the Side Button 1, and press the Emergen-
cy button.
● Wait for console to clear emergency.