Static Ip; Ip Address; Figure 43 Lcd Menu: Static Ip; Figure 44 Lcd Menu: Ip Address - ZyXEL Communications V300-T1 User Manual

Chapter 6 LCD Menus: Advanced
Check whether DHCP is enabled on the V300 or not. If DHCP is disabled (Off), press
enter the DHCP screen and press
Alternatively press
If static IP or PPPoE is enabled, DHCP will be disabled automatically.

6.4 Static IP

Use this menu to manually configure your V300's IP address, subnet mask and gateway
settings. Enter the settings exactly as your ISP or network administrator gave them to you.
Select Adv Setting > Static IP. The following screen displays.

Figure 43 LCD Menu: Static IP

4. Static IP (Off)
The following table describes the labels in this screen.

Table 12 LCD Menu: Static IP

LABEL
Static IP

IP Address

Gateway
Subnet Mask
1st DNS
2nd DNS
6.4.1 IP Address
Select Adv Setting > Static IP > IP Address. The following screen displays.

Figure 44 LCD Menu: IP Address

2. IP Address
0.0.0.0
The number that displays is the static IP address currently configured on the V300. Press
edit the static IP address, or press
56
again to change the configuration (turn DHCP on).
to return to the previous screen.
DESCRIPTION
Select this to turn on static IP. Your V300 uses the IP settings you configure
in this menu. If DHCP or PPPoE is enabled, static IP will be disabled
automatically.
Select this to set the static IP address you want the V300 to use.
Select this to set the IP address of the device your V300 uses to access the
Internet.
Select this to enter the subnet mask your V300 uses.
Select this to enter the primary DNS (Domain Name System) server's IP
address.
Select this to enter the secondary (backup) DNS server's IP address.
to return to the previous screen.
to
to
V300 User's Guide