Zonet ZSR2104WE User Manual page 5

Rear Panel
The rear panel features 4 LAN ports, 1 WAN port and Reset button. Refer to the
following table for the meaning of each feature.
Power (DC 5v)
Reset
LAN
WAN
AP Router Default Settings
The default settings are shown following.
User
Password
AP Router IP Address
AP Router Subnet Mask 255.255.255.0
RF ESSID
11g RF Channel
Mode
Encryption
DHCP client
Used to connect to the power outlet. Only
use the power adapter provided with the
device. Use of an unauthorized power
adapter may cause damage to your device
and violate your warranty.
Press the Reset Button for approximately
ten seconds, all configurations will set to
factory default settings.
The RJ-45 Ethernet ports used to connect
your PC, hub, switch or Ethernet network.
The RJ-45 Ethernet port labeled WAN is
used to connect your AP Router to your
xDSL or Cable modem.
admin
192.168.1.1
wlan-g
6
Disabled
11b+g
11g only
AfterBurner
Disabled
Enabled
5