Zonet ZSR2104WE User Manual page 40

Static Routing,
Destination IP
Address, Subnet
Mask, Gateway,
and Interface
Delete This Entry
Show Routing
Table
1. To set up a static route between the Router and
another network, select a number from the Static
Routing drop-down list. (A static route is a
pre-determined pathway that network information must
travel to reach a specific host or network.)
2. Enter the following data:
• Destination IP Address - The Destination IP Address
is the address of the network or host to which you want
to assign a static route.
• Subnet Mask - The Subnet Mask determines which
portion of an IP address is the network portion, and
which portion is the host portion.
• Gateway - This is the IP address of the gateway
device that allows for contact between the Router and
the network or host.
3. Depending on where the Destination IP Address is
located, select LAN & Wireless or Internet (WAN) from
the Interface drop-down menu.
4. To save your changes, click the Apply button. To
cancel your unsaved changes, click the Cancel button.
For additional static routes, repeat steps 1-4.
To delete a static route entry:
1. From the Static Routing drop-down list, select the
entry number of the static route.
2. Click the Delete This Entry button.
3. To save a deletion, click the Apply button. To cancel
a deletion, click the Cancel button.
Click the Show Routing Table button to view all of the
valid route entries in use. The Destination IP address,
Subnet Mask, Gateway, and Interface will be displayed
for each entry. Click the Refresh button to refresh the
data displayed.
• Destination LAN IP - The Destination IP Address is
the address of the network or host to which the static
route is assigned.
• Subnet Mask - The Subnet Mask determines which
portion of an IP address is the network portion, and
which portion is the host portion.
• Gateway - This is the IP address of the gateway
device that allows for contact between the Router and
the network or host.
• Interface - This interface tells you whether the
40