Stihl RLA 240.0 Instruction Manual page 34

English
► Open both quick-release levers (1) and fold
the lower handlebar section (2) backwards,
hold it at the desired height and close both
quick-release levers (1) again.
► Slide the cable guide (3) onto the screw (4).
► Align centre handlebar section (5) on the lower
handlebar (2) so the bores align.
► Push the screws (4, 6) through the holes from
the outside, insert a washer (7) on the inside
and fix them in place with the turning handles
(8).
► Slide the cable guide (9) onto the screw (10).
► Align the upper handlebar section (11) with the
handlebar centre sections (5) so that the holes
are aligned.
► Push the screws (10, 12) through the holes
from the outside, place a washer (13) onto
each on the inside and fix in place with the
rotary handles (14).
► Press the cable (15) into the cable guides (3,
9).
► Adjust the handlebar to the desired height
using the quick-clamping device (1)
The handlebar must not be dismantled again.
7.2 Removing the Combing Roller
from the Transport Compart‐
ment Before Use for the First
Time
► Switch the lawn scarifier off and remove the
battery.
34
► Place the lawn scarifier on a level surface.
► Open quick-clamping devices (1) and fold
down the handlebar to the rear.
► Hold the lawn scarifier at the lower transport
handle and upend.
► Remove the cable ties.
► Remove the combing roller from the transport
compartment and keep it in a safe place.
7.3
7.3.1
► Pull the fabric (1) over the frame (2) so that
the base plate is at the bottom and the handle
8.1. (3) is on the outside of the fabric.
► Press plastic profiles (4) onto the frame.
The plastic profiles engage with a click.
7.3.2
► Switch the lawn scarifier off.
7 Assembling the Lawn Scarifier
Assembling, Attaching and
Detaching the Grass Catcher
Box
Assembling the Grass Catcher Box
Attaching the Grass Catcher Box
0478-670-9809-C