Vertex Standard VX-2500U Service Manual page 15

The alignment tool outline
Enter to the alignment mode
To enter the alignment mode, turn the receiver off, select
"Radio" then "Alignment" parameter on Clone Editor
"CE52". You turn off the power of the transceiver, and
turn on the transceiver. When the command has been suc-
cessful, a message on the computer screen will confirm
that the transceiver is now in the alignment mode.
Alignment Sequence
Although the data displayed on the computer screen dur-
ing alignment is temporary data, it is important you fol-
low the basic alignment sequence precisely, so that the
displayed data and the data loaded into the transceiver
are identical.
Basic Alignment Sequence
1. Enter the alignment mode
2. Upload data from transceiver
3. Align data
4. Download data to transceiver
L1017
TP1007
VX-2500 UHF Service Manual
RF Unit ( Lot. 6~ ) / RF-1 Unit / RF-2 Unit Test & Alignment Points
Menu of the tool
TX Power (High)
This parameter is used to align TX High power.
 Set the transceiver to CH#1 via the "Channel" box
located upper right corner on the "Alignment"
window previously.
 To adjustment click the left mouse button on the
"Power High" then "Start" button.
Alignment
L1020
VR1001
15