Connections; Power And Swc Wiring - Boss Audio Systems BCPA12 User Manual

Connections

Power and Steering Wheel Control (SWC) Wiring
WARNING
See the section "Installation Warnings". (P.5)
IMPORTANT NOTE
Unused input/output wires need to be insulated
with tape, heat shrink, or crimp connectors.
Never use wire nuts.
Always replace the faulty fuse with the same
type and rating (15A).
Illumination input wire (Orange) must be
connected to the parking light for night
detection and auto dimming in screen and
panel button lights.
Reverse Input wire (Purple/white) must
be connected to the reverse light wire for
automatic rear camera trigger when the gear is
changed to reverse.
* Power output is max. 500mA, 12V. It is
recommended to use a relay if additional power
is required.
** Consult a professional installer for a correct
third-party SWC adapter for your specific
vehicle.
28
FL FR L-IN
R-IN
RL RR
15
SUB1 SUB2 V-IN
15A ATO Fuse
Rear Cam Power Output (Red/white)
Front Cam Power Output (Red/purple)
9 Red
SWC Input (3.5 mm)
White
19
Illumination Input (Orange)
ACC Power Input (Red)
Ground (Black)
Constant Power (Yellow)
Reverse Input (Purple/white)
Antenna Output (Blue)
Remote Output (Blue/white)
Front View
10 9 8 7 6
RADIO
20 19 18 17 16
To rear camera for power supply *
10
To front camera for power supply *
20
To a third-party steering wheel control adapter (not
included), or to your steering wheel control using
the supplied SWC adapter cable **
To vehicle's parking light
18
To ignition key switch (+12V)
17
To vehicle's metal frame/car chassis
16
To positive car battery terminal (+12V)
15
To reverse light for rear camera trigger
14
To car antenna (not included) for power control *
12
To an amplifier (not included) for power control *
11
5 4 3 2 1
15 14 13 12 11