Kohler Stillness Smart Soak K-31404-PF-HW1 Homeowner's Manual page 3

WARNING: The use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia.
Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs when the internal temperature
of the body reaches a level several degrees above the normal body temperature of 98.6°F (37°C). The symptoms of
hyperthermia include an increase in the internal temperature of the body, dizziness, lethargy, drowsiness, and
fainting. The effects of hyperthermia include: (a) failure to perceive heat, (b) failure to recognize the need to exit the
bath, (c) unawareness of impending hazard, (d) fetal damage in pregnant women, (e) physical inability to exit the
bath, and (f) unconsciousness resulting in the danger of drowning.
WARNING: Risk of hyperthermia. People using medications and/or having an adverse medical history should
consult a physician before using a bath equipped with a heater.
WARNING: Risk of hyperthermia and possible drowning. Do not use a hydromassage bath equipped with heater
immediately following strenuous exercise.
WARNING: Risk of hyperthermia and possible drowning. Water temperature in excess of 100°F (38°C) can be
injurious to your health. Check and adjust water temperature before use.
WARNING: Risk of fetal injury. Pregnant or possibly pregnant women should consult a physician before using a
hydromassage bath equipped with heater.
NOTE: Do not use the bath in case of power outage. The electronic drain may automatically open preventing the bath
from filling with water.
Use this bath only for its intended purpose as described in this guide. Do not use attachments that are not recommended
by Kohler Co.
NOTICE: Grounding is required. The unit should be installed and grounded by a qualified service representative.
The bath must be connected only to a supply circuit that is protected by a Ground-Fault Circuit-Interrupter (GFCI)*. Such
a GFCI should be provided by the installer and should be tested on a routine basis. To test the GFCI, press the test button.
The GFCI should interrupt power. Press the reset button. Power should be restored. If the GFCI fails to operate in this
manner, the GFCI is defective. If the GFCI interrupts power to the bath without the test button being pressed, a ground
current is flowing, indicating the possibility of an electric shock. Do not use this bath. Disconnect the bath and have the
problem corrected by a qualified service representative before using.
(For permanently connected units) A green-colored terminal (or a wire connector marked "G," "GR," "Ground," or
"Grounding") is provided within the terminal compartment. To reduce the risk of electric shock, connect this terminal or
connector to the grounding terminal of your electric service or supply panel with a conductor equivalent in size to the
circuit conductors supplying this equipment.
Follow all local plumbing, building, and electrical codes.
*Outside North America, this may be known as a Residual Current Device (RCD).
SAVE THESE INSTRUCTIONS
Kohler Co. 3
1485077-5-B