Advertisement
Connecting
a DTV Receiver,
continued
Note:
The TV back panel and connections
shown
here are for reference
only and may vary by model,
satellite
Figure 13. Connecting
the DTV receiver with RGB
video connections.
DTV Receiver
with RGB Video
(Figure 13)
1.
Connect
the outside
antenna,
cable, or satellite
to ANT or SATELLITE
IN on the DTV receiver
(see your DTV receiver
owner's
guide for
instructions
and cable compatibility).
=
If your DTV receiver
has a built=in terrestrial
tuner, connect
the incoming
terrestrial
antenna
to ANT on the DTV receiver.
If your DTV receiver
does not have a built-in
terrestrial
tuner, this
TV will only be able to provide
an analog signal
through
Ant=A on the TV back panel.
=
Connect
the RGB cables from the DTV receiver
to the TV back panel as listed below (if your
DTV receiver
uses BNC=type
cables,
use the
adaptors
shown
in Figure 11, page 19):
DTV Receiver
TV Back Panel
G (green)
=
YiG
B (blue)
=
PbiB
R (red)
=
PriR
=
=
=
If the DTV receiver
has outputs
for H and
V
sync, connect
as listed below (DO NOT connect
if DTV receiver
uses "Sync on Green"):
H (horizontal
sync)
=
H
V (vertical
sync)
=
Connect
the L (left) and R (right) audio cables
from the DTV receiver
to DTV AUDIO on the TV
back panel.
To utilize the benefits
of a digital A/V receiver,
connect
your DTV receiver's
digital
audio out
to a digital
input on your digital A/V receiver.
You may need to setup the DTV (See Input
Assignment,
page 35) to RGB.
Advertisement
