Advertisement
Connecting
a DVD Player or Other S-Video
Device
Note:
The TV back panel and connections
shown
here are for reference
only and may vary by medel,
DVD
back
panel
[]
Figure, 9. Connecting a DVD Player with Component
Video.
DVD Player with Component
Video
(Figure 9)
1.
Connect
the Component
Video cables from
(YCbCr
or YPbPr)
VIDEO OUT on the back of
the DVD player to COMPONENT
(1 or 2) on the
TV back panel. The correct
connections
are:
A. YtoY
B. Cb or Pb to Pb
C. Cr or Pr to Pr
2.
Connect
a set of audio cables from AUDIO OUT
on the back of the DVD player to COMPONENT
AUDIO
Input (1 or 2) on the TV back panel.
The red came connects to the R (right)channel
The white came connects to the L ([eft) channel
Note:
Note:
Some video game systems
support
DTV
resolutions
via component
connections.
Please refer to your video
game console
Owner's
Guide for setup information.
For optimal
DVD playback
performance,
Mksubishi
recommends
using a progressive
scan DVD player, set to play in progressive
scan mode.
You will also want to set your
player to display
16:9 widescreen.
Please
refer to your DVD player's Owner's
Guide.
TV back
pane[
(section
detail)
Any S=Video Device
Other S-Video
Device
(Figure 10)
1.
Connect
an S-Video
cable from VIDEO OUT
on the device
back panel to VIDEO INPUT-1 or
INPUT-2 on the TV back panel.
.
Connect
a set of audio cables from AUDIO OUT
on the device
back panel to AUDIO
INPUT-1 or
INPUT-2 on the TV back panel, matching
the
input used in step 1.
The red came connects to the R (right) channel
The white came connects to the L ([eft) channel
If your S-Video
Device is mono (non-stereo),
connect
only the white (left) cable.
Figure 10. Connecting
an S-Video Device.
Advertisement
