Table of Contents
Advertisement
Increasing the Number of End-User Systems
A single end-user system is attached to the Hotwire 6390 ReachDSL Modem by
using an Ethernet straight-through cable. To increase the number of end-user
systems, connect all the PCs to an Ethernet hub and connect the modem to the
hub's uplink port using a standard straight-through cable for both connections.
The Hotwire ReachDSL port card supports 32 hosts/subnets per DSL port and the
Hotwire ReachDSL Modem supports up to 256 MAC entries.
Cables & Connectors
Standard twisted-pair CAT3 or better cables are recommended.
T
T
6
The LINE and PHONE interface connectors
use 6-pin, non-keyed modular plugs. RJ11 or
RJ14 6-pin connectors can be used.
Line & Phone Connectors
Pin # Function
1
Not used
2
Ring 2 (optional)
3
DSL Ring 1
4
DSL Tip 1
5
Tip 2 (optional)
6
Not used
The LINE and PHONE jack pinouts are either filtered or unfiltered for POTS.
PHONE Jack Pinouts
Pin # 3, 4
Filtered for POTS
Pin # 2, 5
2nd POTS unfiltered
September 2002
6-Pin
RJ11 Plugs
Pin #6
Pin #1
LINE Jack Pinouts
Pin # 3, 4
DSL and POTS
Pin # 2, 5
2nd line pass-through
6390-A2-GK40-00
98-15304a
Advertisement
Table of Contents
