Table of Contents
Advertisement
Power-On
When power is applied, the ReachDSL modem performs self-diagnostics and the
PWR LED is on. The self-diagnostics includes a power-on self-test and all of the
LEDs turn on for one second.
Status LEDs
All of the LEDs turn on and off during the power-on self-test. After a successful
self-test, the LEDs should appear as indicated in BOLD in the Condition column
below.
Refer to
4
Power – green
PWR
ReachDSL
LED
Condition Status
ON
PWR
ReachDSL modem has power.
ALM
OFF
No active alarms.
ON
An alarm condition exists.
OFF
TST
No active tests.
ON
The TST LED is on during the power-on self-test and during a
test initiated by the service provider.
LINE
ON
The DSL link is active and ready to transmit and receive data.
OFF
The DSL link has not been established.
TX/RX
ON
Data transmission is in progress on the DSL line.
OFF
The modem is not transmitting or receiving data.
ETHERNET ON
The Ethernet connection to the Ethernet hub or PC is active.
OFF
No Ethernet 10BaseT device is detected.
Troubleshooting
on page 5 for LED indications requiring action.
September 2002
Alarm – red
Test – yellow
DSL Line – green
Transmit/Receive – green
ALM
TST
LINE
TX/RX
Ethernet Link – green
ETHERNET
01-17003
6390-A2-GK40-00
Advertisement
Table of Contents
