Static Setup (Red, Blue, Green Convergence) - Zenith Presentation PRO900X Operating Manual

SETUP MENU
Blank Setup (Continued)
Separate menus are available for adjusting the Top/Left and
Bottom/Right of the projected image as well as the Phase.
To adjust any option, simply place cursor over option and
press down on the trackball, to highlight the option.
(Blank Setup is normally adjusted by the installation
technician; usually no additional changes are needed.)
Notes:
• If you make changes to any option, you will be asked to save
them to the currently selected format. If the format is unknown,
store it as a new customer format.
• Access the Trackball menu and press down on the trackball with
the cursor on the Status bar to reveal the format of the currently
selected video source (Video, S-Video or RGB). See page 22.

Static Setup (Red, Blue, Green Convergence)

Occasionally the red, blue, and green images go out of
convergence. In the Static Setup Menu you will see a menu
similar to the one shown at the right. Ideally, the conver-
gence is correct when the bars in the center of the menu
are white.
Adjusting Convergence
Move the cursor to the appropriate Up/Down/Left/Right
icon and press down on the trackball repeatedly to move
the selected color to the center of the bars.
With the cursor on either the Adjusting Red or Adjusting
Blue rectangle, press the trackball down to switch to the
other color alignment menu. Move the newly selected color
using the Up/Down/Left/Right icons (as you did the first
color) to align the color to the center of the bars. The
green does not move; you are moving the red and blue over
the green. When the bars are white, the convergence
realignment is complete.
Move the cursor to the "Exit" icon and press down on the
trackball to leave the menu. Save the changes.
P A G E 2 8
3275-A