Table of Contents
Advertisement
Identifying the Parts
Remote Control Direction
Aim the Remote Commander to the remote sensor within the range as shown below.
Notes on the Remote Commander
• Keep the remote sensor away from strong light sources, such as direct sunlight or illumination.
Otherwise, the remote control may not be effective.
• Be sure that there is no obstacle between the remote sensor and the Remote Commander.
• This camcorder works at commander mode VTR 2. The commander mode (1, 2, and 3) are used to
distinguish this camcorder from other Sony VCRs to avoid remote control misoperation. If you use
another Sony VCR at commander mode VTR 2, we recommend you change the commander mode
or cover the remote sensor of the VCR with black paper.
To Watch the Demonstration
You can watch a brief demonstration of pictures with special effects.
If the demonstration appears when you turn on the camcorder for the first time, exit the Demo mode
to use your camcorder.
To enter Demo mode
(D Remove the cassette and turn the POWER switch to OFF.
(2)
Turn STANDBY up.
(3)
While holding down O PLAY, turn the POWER switch to CAMERA. Demonstration starts.
If a cassette is inserted, the demo mode stops. Note that once you enter demo mode, this mode is
retained as long as the lithium battery is in place. Therefore demonstration starts automatically 10
minutes later every time you turn the POWER switch to CAMERA or 10 minutes after the cassette has
been removed.
To exit Demo mode
(1) Turn the POWER switch to OFF.
(2)
Turn STANDBY up.
(3)
While holding down □ STOP, turn the POWER switch to CAMERA.
60
Advertisement
Table of Contents
