S-Vhs Vcr - Zenith Presentation H25C46DT Installation And Operating Manual, Warranty

Hook Up an S-VHS VCR to your TV
Your Zenith TV may be connected to a Super-VHS VCR through the S-Video Input located on the connec-
tion panel on your TV. Also, you may "daisy chain" up to five TVs to one Super VHS VCR through the spe-
cial S-Video LOOP OUT connection.
1
Hook up your S-VHS VCR to your Zenith TV according to the
diagram below.
2
Remove the back of the remote and put in two AAA batter-
ies.
back of
remote
3
Plug in your TV. Do not plug it into a switched outlet. Your
Zenith TV is designed to operate on standard current, 120-
volt 60 Hertz AC. Do not attempt to operate it on DC
Current.
4
If you wish to "daisy chain" more than one TV to receive
the S-VHS signal, you will need to make the following con-
nections with an S-Video cable, inserting one end of the
cable into the LOOP OUT port with the other end inserted
into a S-Video In port of your second Zenith TV or equiva-
lent input for any other brand of TV.
4
206-3602
ANTENNA
CABLE
COMPUTER
IN
M.P.I.
S-Video cable
not included
with TV
Connect Audio Out
to an external
amplifier and
speakers.
TV back
S-VIDEO OUT
S-VIDEO IN
R- AUDIO- L
R- AUDIO- L
VIDEO
AUX IN
R
AUDIO OUT
R- AUDIO- L
COMPUTER
L
AUDIO
VCR back
VCR back AV panel
output
switch 3 4
S-Video Out Audio Out
R L
P A G E 2 1