Zenith Presentation H25C46DT Installation And Operating Manual, Warranty page 39

Programming the Remote
Program your remote to control a variety of A/ V devices
1
The device you want to program should be ON.
2
Refer to the brand programming codes on pages
43 - 44 to find the type and brand name of the
device you're programming. Make a note of the
three-number code—you'll need it soon.
3
Press and hold the PRG key. It's recessed so it
doesn't get pushed accidentally. When the indica-
tor light turns on, you can release the key.
4
Push the key with the name of the device you're
programming (VCR, CABLE, AUX, TV).
5
Using the NUMBER keypad, enter the three-number
code found on the chart in the Reference section.
6
Press ENTER to save the code The indicator light
will flash three times and turn off if the code was
accepted.
7
Point the remote at the device and push the
POWER key. The device should turn off. If not, try
the other codes listed and continue from Step 3.
Programming your Zenith remote will allow you to use one
remote to work up to 7 different devices!
Not all devices will work with your Zenith remote control.
Mode / Product Compatibility
TV VCR CATV
TVs VCRs Cable Boxes,
Satellite Receivers
206-3492-O
AUX (AUX+1, AUX+2, AUX+3)
All products on pp 43 - 44
3
PRG
Indicator Light
VCR
CABLE
SURF
VOLUME
1
4
5
7
0
MENU
RECORD PAUSE
REWIND
POWER
AUX TV
FLASHBK MUTE
CHANNEL
VOLUME
CHANNEL
2 3
5 6
8 9
ENTER
QUIT
TV/VCR
TIMER
SOURCE
PLAY
FFWD
STOP
P A G E 3 9
7
4
6