Autofind - Zenith H2546DT Installation And Operating Manual, Warranty

Remote Control Auto-Find
If Programming the Remote did not find your code, try this procedure to automatically find
the code for your device. If your remote becomes inoperable, go back to "Programming your
Remote" and enter the Zenith TV code for step five
1
Turn on the device you're programming for the
remote control.
2
Press and hold the PRG key until the indicator light
turns on.
3
Press the key for the device you're trying to program
(CABLE, VCR, AUX, TV).
4
Enter the code 0-0-0 (zero-zero-zero), then press the
ENTER key right away.
5
Aim the remote at the correct device and press
POWER. Allow a second to pass, then push the
POWER key again. Repeat until the device turns off.
(This is a trial and error process, so it may be neces-
sary to repeat these steps until the remote finds your
code.)
6
Push ENTER to save the code.
7
Press POWER to turn the device back on.
You can quickly get out of Auto Find by press-
ing QUIT.
If the indicator light stays on while you push
Power, instead of turning off, all the codes
have been tried and your device can't be pro-
grammed.
P A G E 4 0
2
PRG
Indicator Light
VCR
CABLE
SURF FLASHBK
CHANNEL
VOLUME
CHANNEL
1
4
7
4
0
MENU
RECORD PAUSE
PLAY
REWIND
STOP
5/7
POWER
AUX TV
MUTE
VOLUME
2 3
5 6
8 9
ENTER
QUIT
TV/VCR
TIMER
SOURCE
FFWD
206-3492-O
3
6